4rnd Shotgun Card 12Gauge

Wolf Gray and OD Green are DISCONTINUED. We will not be making any more. 

Installation/use instructions are provided below.

There is hook velcro sewn on the back of the shotgun cards. Made for 12gauge shotgun shells only. The "Add Sticky Back Loop Velcro for $1.50" option is a strip of industrial strength loop velcro with industrial strength adhesive. Choose this option if you would like to attach the shotgun card to your shotguns receiver. Please let the velcro adhere for 24 hours to let the adhesive take a set.

Sizing:  4.5" long x 2"wide

Elastic: 1.5"wide

Black,CoyoteBrown,RangerGreen,Foliage color is mil spec Elastic.

Muliticam color is printed mil spec Elastic.

Instructions:

The Shotgun Card is designed to be used as a "magazine". Reload from the shotgun card first, and then slap another on the side once low/empty. Shotgun cards will fit in our 5.56 and 7.62 pouches, and most 5.56 pouch offerings on the market. 

The shotgun cards, when loaded, will likely take a "C" shape due to the elastic tightening. This is normal. You will want to correct this by bending the shotgun card the opposite direction (while loaded). You can do this by hand. If the bend still remains/returns, bend it again in the opposite direction, and throw a rubber band or tape it, and let it sit for an hour. Remove the binding, and see if the bend still remains/returns. Repeat as needed, for a longer duration if required. We have tested it by leaving shotgun cards taped/bound for a week, and the shells still were retained after shooting. If you have questions/issues please email customer support.

Shotgun cards are disposable items. Like magazine springs, the elastic with use will eventually wear out. This is normal. Like magazines, when they wear out, buy replacments, or have extras on hand to keep/store long term. Getting an extra Sticky Back Velcro to keep on hand is a good idea. Oils and cleaners used to maintain your firearm can soften the adhesive, which would be noticable when the edges of the velcro starts lifting.

Adhesive Velcro Installation:

Take the velcro, and cut it to match your receiver if needed. Take acetone or alcohol, and clean the area where you will mount the velcro, to remove oils/grime/debris. Place the velcro on a clean and VERY DRY surface, and let sit for 24hrs to take a "set". From there, you are good to slap the shotgun cards and remove to your hearts content. 

For "Safe Queen" Shotguns:

We believe a shotgun is a tool, and should be used/treated appropriately. If you are concerned about the finish of your receiver being affected by the install, don't install or use the shotgun cards. Better yet, don't shoot the gun, and let it sit in your safe. While the velcro *shouldn't* effect the finish if the finish is of good quality, this is not a guarantee. 

We are not responsible for damage(s) to a firearm or other item by a customer installing the velcro by their own volition.